Clean-Tear Eye Drop
Manufacturer
Wellona Pharmaceutical Private Limited
Salt Composition
Carboxymethylcellulose (0.5% w/v)
Key Information
Short Description
Clean-Tear Eye Drop is an eye lubricant or artificial tears used to relieve dry eyes by maintaining proper lubrication of the eyes.
Dosage Form
Eye Drop
Introduction
Clean-Tear Eye Drop is usually taken when needed. Use the number of drops as advised by your doctor. Wait for at least 5-10 minutes before delivering any other medication in the same eye to avoid dilution. Do not use a bottle if the seal is broken before you open it. Always wash your hands and do not touch the end of the dropper. This could infect your eye. This medicine may require long-term use and can be taken safely for as long as you need it.
Directions for Use
This medicine is for external use only. Use it in the dose and duration as advised by your doctor. Check the label for directions before use. Hold the dropper close to the eye without touching it. Gently squeeze the dropper and place the medicine inside the lower eyelid. Wipe off the extra liquid.
Safety Information
Side Effects
Eye irritation (including burning and discomfort) Eye pain Eye itching Visual disturbance
Alcohol Warning
No interaction found/established
Breastfeeding Warning
Information regarding the use of Clean-Tear Eye Drop during breastfeeding is not available. Please consult your doctor.
Pregnancy Warning
Information regarding the use of Clean-Tear Eye Drop during pregnancy is not available. Please consult your doctor.
How it works
Clean-Tear Eye Drop is a lubricant. It works similar to natural tears and provides temporary relief from burning and discomfort due to dryness of the eye.
Quick Tips
Your doctor has prescribed Clean-Tear Eye Drop to treat dry eye disease. It stabilizes the natural tear film and maintains necessary lubrication so your eyes don’t get dry and irritated. May require long-term use. Apply pressure on the corner of the eye (close to the nose) for about 1 minute immediately after instilling the drop. Wait for at least 5-10 minutes before delivering the next medication in the same eye to avoid dilution of this medicine.
Related Medicines
CMC Eye Drop
Ontears Eye Drop
Takfresh Eye Drops
Glytears Eye Drop
Aqualube Eye Drop
Addwet Eye Drop
Aquaray Lubricant Eye Drop
Extralube Eye Drop
Eco Tears Eye Drop
Just Tears Eye Drop
Frequently asked questions
What is the purpose of using Clean-Tear Eye Drops?
Clean-Tear Eye Drops are a tear substitute used to lubricate dry eyes and provide temporary relief from burning, irritation, and discomfort caused by dryness. They can also be used to re-wet soft and rigid gas-permeable contact lenses, helping to relieve dryness, irritation, and discomfort associated with lens wear.
What potential side effects may occur when using Clean-Tear Eye Drops?
You may experience visual disturbances, eye discharge, or notice medication residue while using this product. Additionally, some individuals may experience redness of the eye, eye irritation, burning, discomfort, eyelid swelling, and itching of the eye as side effects.
How should Clean-Tear Eye Drops be stored?
Store the product at a temperature of 25°C (77°F) or below. Keep it out of reach of children and avoid touching the tip of the container to any surface. After each use, replace the cap to maintain the product's integrity.
How should Clean-Tear Eye Drops be used?
For dry eyes, instill 1-2 drops in the affected eye(s) as needed. To lubricate soft and rigid gas-permeable lenses, apply 1-2 drops to each eye with the lenses on as needed or according to your doctor's instructions. After pouring the drops, blink several times.
Is Clean-Tear Eye Drops safe to use?
Yes, Clean-Tear Eye Drops are a safe medication for external use only. Although some patients may experience eye irritation (burning and discomfort), eye pain, itchy eyes, or visual disturbances, these effects typically resolve on their own. However, if any of these symptoms persist, contact your doctor immediately.
